1. Press and hold [TV] for 5 seconds. The LED goes from blinking to solid and STB Remote Control Unit will enter Learning Mode.
2. Press the Key to be programmed on T1 plus Remote Control Unit. LED begins blinking slowly.The key is now ready to accept programming.
3. Aim the TV Remote Control Unit towards the front of the Dreamlink T1plus Remote Control Unit (the distance must be less than 3cm).Press the button on the TV Remote control. If the T1 plus Remote Control is programmed correctly, the LED will flash 3 times.
4. Repeat step 2-3 for other keys.5. Exit Learning Mode by pressing any other button on the Dreamlink T1 Plus Remote Control. LED turns off.
Dreamlink T1 Plus Set Up
Dreamlink T1 Box
Free shipping in orders over $100 SAVE UP TO 30% ON THE HOLIDAYS USE COUPON CODE 'HAPPYDAYS'Shop now Paying with PayPal THE BEST EXPERIENCENEW PRODUCT Best decoding technology 4K HDR, HDR10, HLG, 4K 10-bit 60fps h.265, 4K 10-bit 60fps VP9 Decodes Most High Efficiency Video Compression Formats like H.265 and H.264.4K requires compatible 4KRead more. Factory reset file for T1 Please do the following - Unzip the attached file: recoveryfacinit - Copy this to a USB stick. Connect to T1 - Power on T1 and press channel up button on remote control until 'system update' message pops up. May 25, 2019 The remote sensor on the Dreamlink T2 unit receives signals from the remote like a charm. The Dreamlink T1 remote had a tad bit activation delay, which is not the case with Dreamlink T2 remote. The remote wakes up immediately and gets to work as soon as you press the buttons. YOUR DREAMLINK T2 CONTAINS Dreamlink T2 5G. Power supply HDMI Cable Dreamlink Remote. Cut That Cord Today And Start Watching Thousands Of iPTV Channels From Around The World In Super HD/4K/8K Including News, Sports, Movies, TV Series, PPV’s And Much More!